KB46734: In MicroStrategy Web 9.4.1, custom group selector does not have the custom group elements, while in 9.3.1 the selector has elements listed.

This issue has been classified as a defect by MicroStrategy. The impact is limited to MicroStrategy Web 9.4.1 Custom Group selectors. There is no workaround available.

In MicroStrategy Web 9.4.1, custom group selector does not have the custom group elements, while in 9.3.1 the selector have elements listed.

1. In MicroStrategy 9.3.1 Desktop/Web, create a custom group based on Month with two custom group elements (Jan 2010 to Jun 2010 and Jan 2011 to Jun 2011).

1. Create a report with only the 'MonthCustomGroup' and name it Report_2.
2. Create another report with Month attribute and a few metrics.
3. Create a document in MicroStrategy Web and add both reports as datasets.
4. In the new document, create a panel stack (Insert menu > Panel Stack) and place it in the Detail Header section of the document.
5. Drag Report_1 to the new Panel Stack.
6. Create a new drop-down selector (Insert > Selector > Drop-Down) and drag the 'MonthCustomGroup' into it

Ensure the Pane Stack is selected as a target for the selector.

Run the Document and notice the selector shows both custom group elements and the All selection. 

Repeat steps 1 - 9 in MicroStrategy Web 9.4.1 and notice the selector does NOT display the custom group elements, but only the 'All'. The same behavior applies to consolidations as well.  

This has been identified as a defect in MicroStrategy Web 9.4.1.
MicroStrategy will continue to investigate and post updates as soon as they are available.